Ceramicspeed UFO Clean Bearing

• The CeramicSpeed UFO Clean Bearings thoroughly remove grease and grime from within cartridge bearings.
• The unique properties efficiently breakdown grease and allow for simple cleansing of bottom brackets, wheel, headset, and pulley wheel bearings.This is a non-toxic and biodegradable formula - environmentally friendly and safe.Please note the new updated bottle comes with a precision nozzle instead of a pipette for easier storage and shipping.

• Non-toxic and biodegradable formula Thoroughly removes grease and grime from bearings Developed and bottled in Denmark Contains 100ml per bottle Not optimal for general drive train cleaning.
• Safe for carbon, glossy or matte painted, and anodized surfaces Installation Please note the new updated bottle comes with a precision nozzle instead of a pipette for easier storage and shipping.
• Maintenance Preparation When possible, standard maintenance can and should be done without removing the bearings from their cup, frame bore, or hub shell.
• This will limit potential stress or impact damage from knocking out the bearings and reinstalling them.For cranks, remove the cranks, any spacers, and dust covers.For hubs, follow the hub/wheel manufacturers' instructions for removing axle end caps and/or dust covers to access the face of the bearings.With the face of the bearing visible, use a knife edge or flat pick to lift off the bearing seal starting on the inner lip (at the inner race) and carefully lifting up.
• Small, smooth movements will help prevent damaging the seal during removal.
• Once the seal is removed, wipe both sides clean, ensure it is completely flat, and set aside.
• You should now have access to the individual balls inside of the bearing.
• Using a cloth or shop rag, wipe away grease on the face of the bearing, revealing the balls.
• If you see a solid ring, you are looking at the back of the bearing.
• There is no direction to the performance of the bearing, but cleaning and maintenance are easier and more efficient when performed from the face/front of the bearing.
• You may choose to turn the bearing around at this time to allow adequate cleaning and ease of future maintenance.
• Normal cleaning To flush and clean CeramicSpeed bearings, UFO Clean Bearings was developed as a non-toxic easy-to-use bearing cleaner.
• Use the nozzle to add a few drops of cleaner into each bearing (Approx. 0,5 – 2.0mL dependent on the bearing size).
• Rotate the bearing to cause an ‘agitation’ effect inside the bearing.
• After soaking for 3-5 minutes, use compressed air to flush out the grease and contamination.
• Repeat this process a second time if needed to fully clean the bearing.
• Once the bearing is visually cleaned out and rotates smoothly, allow the bearing to air dry prior to applying fresh grease.
• Follow the grease selection and application guide at the bottom of this document for the best performance and longevity.
• Once the grease is applied, reinstall the face seal by laying it on the bearing (the all-rubber side should face out) and evenly pressing it into the groove on the outer race.
• The seal should sit flat and even on the bearing.
• Be sure to take careful note of the direction on any dust covers when reassembling the parts.

Discharge - Pour Biodegradable - Yes Carbon safe - Yes Post application - Leave on

• Country of Origin: Taiwan
• Imported By: Ensign Sports , 502 , Hill Glade , Opp. HDFC Bank Pali Road , Bandra , Mumbai - 400050 , Maharashtra , India. (MH-27)
• Net Quantity: 1N
• Customer Care Address: 291, 10 Main, 5 Block, Jayanagar, Bangalore - 560041.
• Ph: (080)47183232,
• Email: support@bumsonthesaddle.com
• Commodity: Degreasers